Average Reviews:
(More customer reviews)My base was purchased from ebay for less. The column is slightly different. The holder is made completely from plastic. Except for the rod and a metal plate embedded in the rubber foot. If you find a "C" shaped washer in the box, DO NOT discard it. It needs to be pressed onto the rod tip to keep it from sliding out. It should come assembled but mine was not.
Fully assembled my unit stands about 10.5". Depending on the depth of the hole on the bottom of the mannequin head, this raises it up 8 inches, or more. As you swing the metal handle it creates suction on any flat non porous surface. The box claims 8 to 9 hours hold if you wet the base. So far it is holding tightly on a laminated desktop. This makes wig styling on your mannequin head a breeze.
The locking ring for the rod resembles a ship's Tiller wheel. It appears to give a 40 degree slant in any direction. Rotate the wheel counter-clockwise to loosen and clockwise to tighten. Again, no need to over tighten as the rod has a ball with little dimples for gripping. Over tightning can wear them off. Mannequinn heads simply aren't that heavy - even with large wigs.
It should hold any mannequin head nicely and firmly. It will last years providing you don't over tighten the Tiller, or damage the rubber base. Only clean the rubber with mild soap or plain water as not to damage it over time.
Click Here to see more reviews about: Vacuum Stand Mannequin Head Holder
Click here for more information about Vacuum Stand Mannequin Head Holder
0 comments:
Post a Comment